Hi, Guys Remember you need to flush the system after replacing the membrane (waste some water). If you are replacing your existing reverse osmosis membrane please remember to lubricate the o-rings. You should use water resistant silicone lubricant If you donít have any, use plain old dish soap, its slick and it helps clean up. Once you have opened the membrane housing you will see a small plastic tube. That small plastic tube in the center of the membrane is what you want to pull ON. you can run wire thru the hole, or you can just grasp the tube with a pliers. you need to understand that you are only pulling for the first inch of movement. After about the first inch of movement the membrane is free and will come right out. So donít pull to hard or to long. Be prepared for the quick release of the membrane. After you replace the membrane allow the system to fill and then empty it completely.
This post has been edited by kaiakanepi: Jan 23 2014, 12:13 PM